TRENDnet TFM-560E, User Manual

Page: 44 / 54

- 41 -
ƒ
Due to poor telephone line conditions, the modem
may have fallen back to a slower communication
speed. You may need to change the baud rate setting
in your software to match this slower speed. To return
the modem to the higher speed, disconnect the link
and re-establish again.
When using V.42bis or MNP5, some features are
disabled.
ƒ
You may be using a non-streaming protocol, like
Xmodem or Ymodem to transfer files. Those are fine
unless you are using V.42bis or MNP5
ƒ
When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.
ƒ
Configure your software to use hardware flow control
(RTS/CTS ON).
When the modem is connecting to another modem, it
reports a higher connect baud rate that it is really
using.
ƒ
The modem defaults to report the modem-to-computer
baud rate when it responds with CONNECT.
ƒ
Go to command mode with your communication
program (like Telix) and type ATW2, then press Enter.
This tells the modem to report the modem-to-modem
baud rate instead.