TRENDnet TEG-30102WS, User Manual, Page: 37 / 109

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-30102WS
33
Configure your port priority
Bridge > Trunk Config > Port Priority
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on Bridge, click on Trunk Config, and click on Port Priority.
3. Review the settings. Click Apply to save changes.
To assign a port higher priority within a trunk group, find the port number and in the
priority column, enter a priority value 0-65535 (65535 being the highest priority).
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Mirroring
Configure port mirror settings
Bridge > Mirroring
Port mirroring allows you to monitor the ingress and egress traffic on a port by having
the traffic copied to another port where a computer or device can be set up to capture
the data for monitoring and troubleshooting purposes.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on Bridge and click on Port Priority.
3. Review the settings. Click Apply to save changes.

Status – Click the drop-down and list and select one of the following options:
o
Enable - This parameter activates the Port Mirroring feature and the
rest of the configuration parameters become active on the page.
o
Disable - This parameter de-activates the Port Mirroring feature and
the rest of the configuration parameters become inactive on the page.

Mirror Target Port – Click the drop-down and list and select the port to send
the copied ingress/egress packets/data. (e.g. Computer or device with packet
capture or data analysis program.)
Check the port to monitor or copy inormation from. (Source)
To copy data received on a specific port, check the port number(s) under the Ingress
Port section or you could click All to copy data received on all ports.
To copy data transmitted on specific port, check the port number under the Egress Port
section or you could click All to copy data transmitted on all ports.