Combi 1001
-16-
Routing the Mitre Corner Joint
Cut with
laminate
down
Cut with
laminate up
Cut with
laminate
down
Cut with
laminate up
Postform edge
Postform edge
Postform edge
Optional accessory
clamp PJ/CL/L on
underside
Quick action
clamp here
Postform edge
Direction of
router travel
Location bushes
(Blue dot)
Optional accessory
clamp PJ/CL/S on
underside
Corner Radius
Special Note: Due to the nature of this
particular edge laminate, the corner radius
will be more awkward to laminate.
Insert the three location bushes in holes
marked Black dot as shown opposite.
Locate the template on the worktop as
illustrated ensuring the location bushes are
touching the worktop edge. Clamp into
position with quick action clamps.
When cutting the radius hold the router guide
bush against the template radius. Feed left to
right.
It is recommended that
the router depth stops are
used and three or four
cuts are taken.
Cut with laminate
down
Cut with laminate
up
Routing the Corner Radius
Quick action
clamp here
Postform edge
Location bushes
(Black dot)
Direction of
router travel
Plan View of
Corner Joint
Cuts
22.5° Mitre Joint
■
For the left hand part of the 22.5 mitre joint
fit bushes into holes marked with a Blue
dot. The Blue dot will be uppermost.
■
Clamp jig using quick action clamps or
accessory clamps.
■
When cutting, keep guide bush against
edge of template. Feed left to right into the
postform edge.
■
For opposing joint keep bushes in the
same side.
■
Repeat above operations for remainder
of joint.
