Combi 1001
-18-
Guarantee
■
The jig carries a manufacturers guarantee in
accordance with the conditions on the
enclosed guarantee registration card.
Recycling
■
Jig, accessories and packaging should be
sorted for environmentally friendly recycling.
45° End Cut
Insert the three location bushes into holes
marked Grey dot as shown below.
Locate the template on the worktop as
illustrated ensuring that bushes are touching
the worktop edge. Clamp using two quick
action clamps.
It is recommended that depth stops are used
and three or four cuts taken. Cut from left to
right. Grey dot must be uppermost when
routing.
Routing the 45° End Cut
Quick action
clamp here
Postform
edge
Location bushes
(Grey dot)
Direction of
router travel
Cut with
laminate
down
Cut with
laminate
up
Postform edge
Postform edge
Postform edge
Postform edge
Peninsular
Peninsular End Cuts
IMPORTANT!
In order to prevent break out of
the laminate, rotation of the
cutter and feed direction of the
router must always be into the
postform edge of worktop.
