8/05/08
17
Section 4: Operating Instructions
4220ST & 4420ST Light Utility Vehicles 700-504M
Table of Contents
Shift Selector and Park Brake
Refer to Figure 4-6:
#16
Shift Selector & Park Brake Control: Sets and
releases the park brake and changes trans-axle
gears from neutral to forward or reverse. Always
start engine in park or neutral.
• To place trans-axle in neutral from park position,
move shift selector up and over to the left and then
pull straight down to neutral position.
• From neutral, move shift selector over to the right
and up to place trans-axle in forward gear.
• From neutral, move shift selector over to the right
and down to place trans-axle in reverse gear.
• Make a full stop by letting up on accelerator pedal
and applying brakes before returning shift selector
to park or switching from reverse to forward and
forward to reverse.
Shift Selector Shown in Park
Figure 4-6
16
22482
Choke
Refer to Figure 4-4:
#13
Choke Control: Located under the driver’s seat.
Use to choke engine when starting. Pull on knob to
start a cold engine. Release knob after engine has
started. Do not choke an engine that is hot from
operating, engine flooding may result.
Figure 4-4
Floor Pedals
Refer to Figure 4-5:
#14
Brake Pedal: Applying pressure to brake pedal
instead of accelerator pedal with your foot will slow
down and/or stop vehicle. Riding or resting your foot
on the pedal unnecessarily will wear the brakes out
prematurely.
#15
Accelerator Pedal: Changes engine rpm and
vehicle ground speed. Press down on the
accelerator pedal with your foot to increase speed
and let up on the pedal to decrease speed. Vehicle
should not move when engine is idling. Adjust
engine idle speed if vehicle moves while accelerator
pedal is not being depressed.
Figure 4-5
13
22386
15
24694
14
