8/05/08
13
Section 3: Pre-Delivery and Check List
4220ST & 4420ST Light Utility Vehicles 700-504M
Table of Contents
Section 3: Pre-Delivery and Check List
Pre-Delivery Certificate
The dealer is required to complete Land Pride’s
“Certificate of Light Utility Vehicle Pre-Delivery” form
before customer may take possession of vehicle. The
information must be filled in and check list checked off or
initialed by individuals performing the checks.
Dealership’s name, signatures of individuals filling in the
form, seller’s signature, customer’s signature and signing
dates are also required before the form is returned to
Land Pride. Below is a list of the information found in the
form that is required to be completed and checked off.
Each vehicle must undergo a Pre-Delivery Inspection by the Dealer. Listed below is an example of the checklist that
is included with the Warranty Registration that is to be submitted to Land Pride upon Retail Sale. The Pre-Delivery
Certificate and Warranty Registration must be submitted to Land Pride in order to activate the vehicle warranty.
___Inspect air cleaner element. Make certain it is clean
and in place.
___Inspect fuel tank to make sure it is properly installed
and that there are no leaks.
___Check fuel level in tank. If needed, add gasoline with a
fuel stabilizer to perform initial starting operations.
See "Fuel System" instructions on page 29 before
adding fuel.
___Inspect fuel lines to make sure they are properly
installed and that there are no leaks.
___Check steering by executing a full lock to lock turn in
each direction.
___Check park brake to make sure it will engage, hold and
release.
___Make sure neutral start feature is working by trying to
start unit while shifter is located in the forward and
reverse positions.
___Check throttle control to make sure it moves and
returns freely.
___Check choke control to make sure it moves and
returns freely.
___Check Rear Trans-axle oil level at the oil plug. Add
Land Pride special formulated gear lube noted on
page 39 if oil is low.
___Check overall appearance for cleanliness and for body
and molding damage.
NOTE:
Vehicles are shipped from the factory with
about a quart of fuel in the tank
.
Dealer Service and Inspection List
___Fully charge battery. Check battery voltage to verify
that it is fully charged.
___Connect negative battery cable. (Negative battery
cable is disconnected before leaving factory and is to
be disconnected after initial dealer set-up to prevent
battery discharge while setting on the dealer’s lot.)
___Check tire pressure to make sure front and rear tires
have a minimum of 7 psi. See "Tire Inflation Chart" on
page 26.
___Make sure wheel lug bolts/nuts are tightened to 90
Newton meters/(65ft. lbs.).
___Check master cylinder to make sure it is filled.
___Check engine oil level at the dipstick. Add SAE 10W30
oil if oil is below the full mark on the dipstick. Do not
overfill.
___Check engine for correct RPM. Set to factory
specification if needed. (See page 45)
___Check Tie Rods for tightness.
___Step on foot brake to make sure there is plenty of
pedal and that brakes hold pressure and do not bleed
off. Add brake fluid and bleed brakes if required.
___Make sure seats and seat belts are properly fastened
to vehicle frame if so equipped.
___Make sure all safety decals are in place.
___Check headlights to make sure they are working and
are properly mounted.
___Check tail lights and brake lights to make sure they are
working and are properly mounted.
Vehicle Information
Model No.
_________________
Date
_________________
Serial No.
_________________
Engine Serial No.
_________________
