2021 E-Caliber Service Manual
9
IsoStrut remote lockout cable
Tools
• Cable cutter
•
Torque wrench with 2 mm hex bit
1. Install the cable in the remote lockout.
2.
Route the cable through the hole in the bottom of the
top tube just in front of the IsoStrut and out the drive
side of the head tube hole.
3. At the head tube, route the wire through the cable.
4. At the IsoStrut, slide the ferrule on the wire.
5. Guide the wire through the slot in the cable stop.
6.
Route the wire around the lockout spool and install
the set screw. Torque to 1Nm.
Drive side
Non-drive side
7. Test that the mechanism works satisfactorily.
8.
Cut the wire to the appropriate length (20-30 mm)
and crimp an end cap on it.
