16
EN
M
use GP
minipool
First run
1
FIllIng ThE MInIPool
Perform a preliminary cleaning of the minipool using a
bit of water and a mild detergent.
Do not use cloths or cleaners that are abrasive, aggressive
or that contain solvents because they could irreparably
damage the surface of the minipool.
Do not start any operation until the minipool has
been completely filled, otherwise the minipool
could be damaged.
Before filling, once again check the quality of the water
supply. This is very important for the well-being of the
users and for the long life of the minipool.
for more information see chapter “Characteristics
of the water supply” on page 12
FIllIng
For filling, use a rubber hose as shown in the figure.
The water used must meet the requirements detailed in
the previous pages and summarised here:
potability
Hardness (TH): between 10°f and 25°f
(100 mg/l-250 mg/l)
pH: between 7.4 and 7.8
Alkalinity: 80 and 125 mg/l (8-12.5°f)
Fill the minipool until the water reaches about 6-7 cm from
the upper edge and in any case until the “LL” indication
disappears.
Manual filling with a garden hose
