Modellbau Lindinger GmbH
Alte-Post-Str. 14 A-4591 Molln e-Mail:
www.lindinger.at
1 • VELINEON POWER SYSTEM
Velineon System Installation
4.
Remove the Speed control’s XL-5 plug from Channel 2 of your
receiver (
see wiring diagram, next page
).
5.
Remove the two 3x12mm washerhead screws that hold the XL-5 to
its mount (
C
). Remove the XL-5.
6.
Remove the four 3x8mm washerhead screws from the ESC mount.
Remove the mount and discard (
D
).
Installation of the Velineon System
:
1.
Install the included ESC mounting plate using the 3x8mm screws (
E
).
2.
Mount the VXL-3s to the new mounting plate using the supplied
3x15mm cap screws (
F
).
3.
Mount the Velineon Motor to the gearbox using the 3x8mm
washerhead screws (or the included flathead hex screws) and tighten
finger tight (
G
, white arrows
).
4.
Mount the motor pinion to the motor shaft, make sure to tighten set
screw against the flat portion of the shaft (
G
).
5.
Set the gear mesh by running a narrow strip of notebook paper into
the gear mesh. Loosen the motor screws and slide the motor and
pinion gear into the spur gear. Retighten the motor screws and then
remove the strip of paper (
H
).
6.
Replace the gear dust cover and the wheel.
7.
Connect the Velineon motor wires and the VXL-3s receiver wire
according to the wiring diagram (
see next page
).
8.
See page 16 for VXL-3s setup and operation.
C
D
E
F
G
H
Motor
Screws
Strip of
Paper
