Modellbau Lindinger GmbH
Alte-Post-Str. 14 A-4591 Molln e-Mail:
www.lindinger.at
VELINEON POWER SYSTEM • 1
VxL-3s Setup and Operation
1.
With the transmitter on, press and release the EZ-Set
button. The LED will shine green. This turns the VXL-3s on.
2.
Apply forward throttle. The LED will turn off until full
throttle power is reached. At full throttle, the LED will
illuminate green.
3.
Move the trigger forward to apply the brakes. Note that
braking control is fully proportional. The LED will turn off
until full braking power is reached.
At full brakes, the LED will illuminate green.
4.
Return the throttle trigger to neutral. The LED will
shine green.
5.
Move the throttle trigger forward again to engage reverse
(Profile #1). The LED will turn off. Once full reverse power is
reached, the LED will illuminate green.
6.
Return the throttle trigger to neutral. (
Note
: There is
programmed delay when changing from reverse to
forward. This prevents damage to the transmission on
high-traction surfaces.)
7.
To turn the VXL-3s off, press the EZ-Set button until the
LED turns off (.5 seconds).
VxL-3s Profile Selection
The speed control is factory set to Profile #1 (100%
forward, brakes, and reverse). To disable reverse (Profile
#2) or to allow 50% forward and 50% reverse (Profile
#3), follow the steps below. The speed control should be
connected to the receiver and battery, and the transmitter
should be adjusted as described previously. The profiles
are selected by entering the programming mode.
Profile Description
Profile #1 (Sport Mode):
100% Forward, 100% Brakes, 100% Reverse
Profile #2 (Race Mode):
100% Forward, 100% Brakes, No Reverse
Profile #3 (Training Mode*):
50% Forward, 100% Brakes, 50% Reverse
Selecting Sport Mode
(Profile #1: 100% Forward, 100% Brakes, 100% Reverse)
1.
Connect a fully charged battery pack to the VXL-3s and
turn on your transmitter.
2.
With the VXL-3s off, press and hold the
EZ-Set button until the LED turns solid
green, then solid red and then begins
blinking red (indicating the Profile #).
A
Green to Red to Off
*patent pending
