Modellbau Lindinger GmbH
Alte-Post-Str. 14 A-4591 Molln e-Mail:
www.lindinger.at
VELINEON POWER SYSTEM • 11
The following instructions cover installation of the Velineon System in an XL-5 equipped Rustler (Model 3705), Bandit
(Model 2405) or Stampede (Model 3605). The Velineon System is capable of extreme power, and the drivetrain upgrades
below are recommended to increase the performance and durability of the XL-5 equipped model being upgraded to
Velineon Power.
Minimum recommended XL-5 equipped vehicle component upgrades:
2381X
Main diff with steel ring gear/ side cover plate/ screws (Bandit, Stampede, Rustler)
2753X
Stub axles, rear (2)
4628R
Differential output yokes, black (2)/ 3x5mm countersunk screws (2)/ screw pin (2)
3696
Idler gear, steel (30-tooth)
Additional suggested XL-5 equipped vehicle component upgrades:
3647
Nuts, 4mm flanged nylon locking (steel, serrated) (8)
3752
Stub axle carriers (2) (requires 5x11x4mm bearings)
3736
Steering blocks, left & right (2) (requires 5x11x4mm bearings)
5116
Ball bearings, blue rubber sealed (5x11x4mm) (2)
Removing the XL-5 system
1.
Remove the right rear wheel (passenger rear).
2.
Remove the two 3x6mm screws from the gear cover and remove
the gear cover (
A
).
3.
Loosen the motor pinion gear set screw (
B,
yellow arrow
) and slide
the gear off the motor shaft. Disconnect the motor wires and loosen
the two 3x8mm washerhead screws until the motor is free of the
gearbox (
B
). Remove the motor.
Velineon System Installation
A
B
Screw Options Note: Other than the 3x15mm
cap screws for mounting the servo to the
servo plate, all the original hardware on your
model can be reused. 3x8mm flathead hex
screws are included if you wish to upgrade
your motor screws to hex hardware.
