Travis Industries Medium Flush Wood Hybrid Fyre Insert, Manual

Page: 194 / 236

6 Stove Installation
(for qualified installers only)
© Travis Industries 4/27/2021 - 1496 Med Flush Wood Insert
Installation Options

Masonry Fireplace Insert

Zero-Clearance (Metal) Fireplace Insert
Features

Single Air Control

Steel Plate Construction (Up to 5/16")

Heavy Duty Refractory Firebrick

Standard High-Tech Blower
Heating Specifications
Approximate Maximum Heating Capacity (in square feet)* 1,500 to 2,000
EPA Tested Cord Wood BTUs per Hour** 14,483 to 69,982
Maximum Burn Time Up to 10 Hours
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the quality and moisture level of the fuel.
** EPA tests to determine BTU output are achieved with a single load of wood at each burn rate. At home, you are likely to add
more wood to your insert to maintain your desired comfort level. By the simple process of loading your fireplace insert with
additional wood, you could achieve up to a 20% higher heat output than established during EPA testing.
This model was tested for efficiency using method B415.1-10 and was determined to have a weighted average Higher Heating
Value (HHV) Overall Heating Efficiency (OHE) of 76.36%. Overall efficiency of the heater may be lower if the heater is
operated without a heat exchange blower or with the installed heat exchange blower turned off.
Dimensions
Figure 1
(a) Measure clearances from base of insert (b) Fireplace Opening
Emissions and Efficiency
This heater meets the 2020 U.S. EPA’s cord wood emission limits for wood heaters. Tested to EPA Alt-125,
ASTM E3053-17, ASTM 2515-11, CSA B415.1-10 this heater has been shown to deliver heat at rates
ranging from 14,483 to 69,982 BTU/hr and an emission value of 1.74g/h. Report No. 0028WN118E