Transition Networks
N-TGE-SFP-02 User Guide
33819 Rev. A
Page
7
of
22
2. Installation
Package Contents
Before you start installing the N-TGE-SFP-02, verify that the package contains these items:
•
One N-TGE-SFP-02 NIC
•
One Low Profile Mounting Bracket
•
One Product Documentation Postcard (33504)
The drivers and this manual are at
. Notify your sales representative immediately if any of
the above items are missing or damaged. Please save the packaging for possible future use.
Cautions and Warnings
Circuit devices are sensitive to static electricity, which can damage their delicate electronics. Dry weather
conditions or walking across a carpeted floor may cause you to acquire a static electrical charge.
To protect your device, always:
•
Touch the metal chassis of your computer to ground the static electrical charge before you pick up the
NIC.
•
Pick up the NIC by holding it on the left and right edges only.
Before installing the N-TGE-SFP-02, ensure that the system meets the hardware and software requirements
listed.
Any PCIe slot with the proper configuration is acceptable for connection. If the card is installed in a PCIe slot
with fewer lanes than the card requires then the adapter card will not provide the optimum data transfer. When
more than one PCIe slot is available make sure to use the PCIe slot with the proper configuration.
Safety Warnings
These products are not intended for use in life support products where failure of a product could reasonably be
expected to result in death or personal injury. Anyone using this product in such an application without express
written consent of an officer of Transition Networks does so at their own risk and agrees to fully indemnify
Transition Networks for any damages that may result from such use or sale.
Installation Instructions
: Read all installation instructions before connecting the equipment to the power
source.
Over-temperature
: This equipment should not be operated in an area with an ambient temperature exceeding
the maximum recommended.
During Lightning - Electrical Hazard
: During periods of lightning activity, do not work on the equipment or
connect or disconnect cables.
Equipment Installation
: This equipment should be installed, replaced, or serviced only by trained and qualified
personnel.
Equipment Disposal
: Disposal of this equipment should be in accordance to all national laws and regulations.
Local and National Electrical Codes
: This equipment should be installed in compliance with local and national
electrical codes.
