TransAct EPIC 630, Programmer'S Manual

Page: 141 / 200

&& &
'
&& 8 ,
!
#
The
141 ) + # + 1 1) # 9 4
1 1 $ + 9 1 1) $ 1 $+ $ 1
&& # : ;< = '> 4 1) $ ?& #
Function
Set Transport Mode and Maximum ticket Loop
ASCII [ESC] I <f><v>
Hexadecimal 1BH 69H <f><v>
Decimal <27> <105> <f><v>
Description This command configured the transport operation and sets the maximum
ticket loop allowed to be captured by the transport. There are three
features configured by this command. This first is if the transport will hold
or drop the delivered ticket. The second is if the Cut command will
automatically deliver the ticket through the transport. The third is how
long of a ticket may be stored in the transport before it is cut.
Where:
f = Feature and v = setting
if f = 1 then v sets the Maximum ticket that can be stored in the transport.
where v = 3 to 16 inches.
if f = 2 then v sets the Drop of Hold setting.
where v = 1 for drop and 0 for hold.
if f = 3 then v sets the Cut and transport mode.
where v = 0 the cut command will also transport the ticket. If v = 1 the cut
will not transport the ticket. The ticket must be transported by command.
Function Deliver Ticket
ASCII [ESC] k
Hexadecimal 1BH 6BH
Decimal <27> <107>
Description This command will deliver a previously cut ticket. This command requires
that the Cut/Transport mode be set to cut only.
Function
Transport Feed
ASCII [ESC] j <n>
Hexadecimal 1BH 6AH <n>
Decimal <27> <106> <n>
Description This command feeds the transport independently of the print paper feed.
This command may be used to drop a previously held ticket or clear the
transport on error. This feed is based on the current vertical motion unit
which is typically 203 steps per inch.