6
BAS-SVN141D-EN
Step 2: Install BCI-R and Air-Fi
®
Wireless (Optional)
Step 2: Install BCI-R and Air-Fi
®
Wireless
(Optional)
If required for this site, install the BCI-R and Air-Fi
®
Wireless. Use the wiring harness
provided with the BCI-R to wire from the RTRM(J-4, 5-pin connector) to BCI-R(J-1, 4-pin
connector).For more information see Installation guide BACnet
®
Communication
Interface for ReliaTel™ Controllers (BCI-R) For use with Voyager™, Odyssey™ and
Precedent™ rooftop units Ordering Number: KIT15864 (RF-SVN03*-EN). Set the BCI-R
and WCI rotary address switch appropriately per the submittal.
Important:
Before plugging in the Air-Fi card, power down the rooftop controller, per
instructions in the installation instructions RF-SVN03A-EN. Then power the controller
and Air-Fi card together.
Install the Air-Fi Wireless Interface, per the instructions, with the wire harness provided.
When using the Air-Fi with the BCI-R, set the BCI-R link switch as shown in
. See
Integration Guide BACnet Communications Interface for ReliaTel Controllers (BCI-R)
(BAS-SVO09*-EN) for more information.
Note:
Ensure Air-Fi
®
Wireless and zone sensors are addressed per the submittal.
Figure 2.
BCI-R and Air-Fi wireless interface
Summary of Contents for Tracer Concierge BMTC015ABC012000
Page 19: ...BAS SVN141D EN 19 Notes...
