Trane 4TXK6512G1000AA, Service Manual

Page: 86 / 187

Step 1: Open the two snaps in the directon of
arrow rille
mak
(3) Installing the panel
1) Please remove the four (4) angle trim panels . Removal method: Flip the jack catches of the angle trim panel in
St p 1 Op n e aps th d o a w
the order of c c c c , as shown in the following figure . The flipping direction is indicated by the arrows . Then the
angle trim panel can be removed.
Jack catch
2) Pull out the two (2) U-shaped hooks on the indoor unit from below .
3)Adjust the panel direction to make the angle side engraved with”Pipe side” consistent with the refrigerant pipe of
the indoor unit, and make the angle side engraved with “Drain side” consistent with the drain side of the indoor unit .
Then hang the 2 hooks in the inner side of the panel on the 2 U-shaped hooks of the indoor unit .
4) Finally fix the panel on the indoor unit with the bolts (M5*25) and gaskets delivered with the unit .
Caution: Gaskets must be used for fixing, or else the panel would be easy to fall off .
Angles trim cover Panel
4 5 °
Step 2: open
the air-inlet
grille to
make it at
45° to the
panel.
the Air-inletair-inlet grille
g
Step 3: Gently
push the air-
inlet grille in
the direction
of arrow
Jack catch
1
2
Jack catch
3
Jack catch
4