16
TRAK Machine Tools
Southwestern Industries, Inc.
Airwolf EVO 3D Printers - Installation, Printing, Maintenance & Troubleshooting Manual
3.5
Installation of Additional Components
In this section, you will install the printer’s top cover, the build plate and connect the printer to a power
source and power it on.
3.5.1.
Top Cover
Steps
Images
1.
Open the front printer door, and put one
hand inside towards the top of the
printer.
2.
With your other hand, place one side of
the glass on the two rear support tabs.
3.
With the hand inside the printer, use your
finger to support the bottom of the glass.
4.
Slowly lower the glass, until the glass is
laying down evenly on all eight (8)
support tabs.
3.5.2.
Install Glass onto bed
Steps
Images
1.
Using two hands, carefully slide the build
plate into the metal bed brackets located
on both sides of the print bed.
2.
Slide the plate all the way in until it is
flush with the back of the print bed.
NOTE
–
You may push down on the build
plate slightly, to get it to slide smoothly.
