MIU-1500 / CompuCount User’s Guide
Page 7
Changing the MIU’s Name
Click on the "Manager" link of the setup menu.
From this page you can enter a name for the MIU-1500 Count Manager. You
can set the maximum amount of time that may pass between sensor
transmissions before the sensor is declared offline. You may set the
"Auto Add" mode for the MIU-1500.
The default "Auto Add" mode is "Service Mode."
"Service Mode" means the MIU-1500 will only add sensors to its list if it
receives a sensor packet that has been sent by pressing the Smart Switch on
the receiver (Traf-Sys Wireless Beams) or holding the magnetic wand at top
right facing corner of the unit (Pulse Transmitter).
"All" means that the MIU-1500 will add a new sensor any time it
receives a transmission from a sensor that is not already in its list.
"Off" means that the MIU-1500 will never add new sensors to its sensor
table.
Adding Sensors
The MIU-1500 Count Manager by default adds sensors to its configuration list when it receives a packet that has
been transmitted in "Service Mode." You can send a transmission in service mode by pressing the Smart Switch on
the receiver (the unit with the LCD display - you will need to press this switch twice within 20 seconds)
of the counter sensor (Traf-Sys Wireless Beams) or holding the magnetic wand at top right facing corner of the
unit (Pulse Transmitter).
CAUTION:
If you are adding a MIU-1500 to an existing counter setup, this will erase all counts.
The MIU-1500 will add counters to its configuration and you may view their data from the main browser screen.
You may need to refresh the screen a couple of times before the counter shows up.
Once you are finished adding counters, return to the Manager
‟s Setup screen and turn the „Automatically add
senso
rs‟ selection to “Off.”
