User Manual
THIS DOCUMENT IS UNCONTROLLED WHEN PRINTED
Page
24
of
34
7.8.
GSM mobile phone access control
The GSM mobile phone access control is another suitable solution for longer term access control
points at locations such as worksites. Vehicles call or text the number that raises the boom.
It is recommended that the GSM controller be installed by an approved service technician, contact
your distributor or us directly.
STEP 1
–
Install access control program:
•
A USB stick will be provided with the software.
•
Install the software onto a computer and follow the instructions.
STEP 2
–
Install sim card.
•
Ensure the product is turned off prior to installing the sim card.
•
Open the main compartment on the product.
•
Disconnect both terminal blocks from the GSM Mobile Phone Access Controller.
•
Detach the GSM Controller by removing the two cable ties.
•
Open the back of the controller, insert the pre-paid 3G SIM card and turn the switch to ON.
•
Secure back of the unit, refit GSM controller with cable ties and connect terminals blocks.
•
Turn the product on
–
Power “ON” LED will illuminate and the 3G LE
D will also illuminate.
•
Close the main compartment on the product.
STEP 3
–
Establishing a connection using the software:
•
Refer to the GSM mobile phone access controller guide for programming and operation
instructions.
•
https://www.elsema.com/wp-content/uploads/2019/05/g-2000.pdf
STEP 4
–
Establishing a connection using a text message:
•
The accessory factory settings password is 1234.
•
Establish a connection to the sim card via test message.
•
Message 1234TEL and the sim card number followed by # (e.g. 1234TEL0406000000#).
•
Ensure uppercase is used and press send.
STEP 5
–
Setup authorised mobile numbers using a text message:
•
To add an authorised number, a sequential text message must be sent for each number.
•
This will require the addition of an A and 001 to the message in step 4.
•
Message 1234TELA001# and the sim card number followed by #.
•
For example, 1234TELA001#0406000000#.
•
Repeat this process for additional numbers ensuing a sequential numbering sequence is
adopted e.g. A002, A003, A004. Ensure uppercase is used and press send.
