Traeger 9352-USB, User Manual, Page: 17 / 93

Söllnerstr. 9 92637 Weiden info@traeger.de +49 (0)961 48 23 0 0
MPI-USB user manual 17 / 93 2022/01/21 01:28
00 ⇒
the station number of the MPI – cable. (Default is „0“) (In the system configuration click on „Set
PG/PC interface“. In the following dialog click “properties”. Now you can change in the registry
card “MPI” part “station-related” the “adress” of the cable.) (In the PG 2000 software you can find
it by clicking on „Options“
„Interfaces“. Close to the bottom of the dialog you can change the „local address“
of the cable.)
¯ ⇒
Second Line
! ⇒
(Exclamation mark) specifies the connection type to the PLC. Display Description ! Directly
connected to the PLC. ? Not directly connected to the PLC. ! (inverse) Directly connected to the PLC
with passive unit of the PLC. ? (inverse) Not direct connected to the PLC with passive unit of the
PLC.
02 ⇒
is the station number of a connected and active PLC in the MPI - BUS.
Every 750 milliseconds (a ¾ second) another user will be displayed if more then one user has been
found.
AG ⇒ The type of the protocol which is used for the cable to run up to the computer.
Display Description
AG
Unknown because there is no connection or an older protocol version (before 5.0) is used.
Ag v5.1 Protocol
ag v5.0 Protocol
04
⇒ Shows the station number of the device, which is connected in that moment with the computer
software (in this example station number 04).
Configuration specific messages:
With the following baud rate settings, the menu message changes accordingly:
Baud rate – configuration 1. line 2. line
PPI 9,6k – (PPISER96) PPISER96 ACTIVE
PPI 19,2k – (PPISER19) PPISER19 ACTIVE
PPI 187,5k – (PPIMulti) ???PM? ????
PPILAN – (PPILAN) PPILAN ACTIVE
PPIUSB – (PPIUSB) PPIUSB ACTIVE
SONDSER SONDSER 19,2 kBaud 8N1
SONDUSB SONDUSB 38,2 kBaud 7E2
Description 8N1:
8 = Data bits
N = Parity
1 = Stop bit
6 Implementing
Connect your module as described in the chapter “ Hardware installation ” to the PLC and to the
programming device or to your computer.
If you want to respond to a PLC via the module you have to comply the requirements as descript in the
chapter “
system requirements ” . In addition,please make sure that the module is properly connected
6.1 First Configuration
Key Display Description