MAINTENANCE
CAUTION!
For your own safety, turn the switch OFF and remove the plug
from the power source outlet before maintaining or lubricating
your drill press.
Frequently blow out, using an air compressor or dust vacuum,
any dust that accumulates inside the motor.
A coat of automotive paste wax applied to the table and column
will help to keep the surface clean.
CAUTION!
To avoid shock or fire hazard, if the power cord is worn or cut
in any way, have it replaced immediately by a licensed
electrician.
LUBRICATION
All of the drill press ball bearings are packed with grease at the
factory. They require no further lubrication.
Periodically lubricate the gear and rack, table elevation
mechanism of the spindle the rack (teeth) of the quill.
CHANGING THE LASER GUIDE BATTERIES (FIG. 26)
Unplug your drill press.
CAUTION!
Failure to unplug your tool could result in accidental starting
causing possible serious personal injury.
1. Pull on the lip of the cover (1) and remove the battery cover.
2. Remove and replace the two batteries.
3. Replace the battery cover.
NOTE:
Replace the batteries with batteries that have a rating of
1.5 volts (Number 4 series and AAA size or equivalent). When
replacing the batteries, the battery terminals should be
thoroughly cleaned. Use a soft paintbrush or similar device, to
remove all sawdust and debris.
Fig. 26
19
1
Summary of Contents for DP12LW
Page 7: ...CARTON CONTENTS 7 L M N O ...
Page 22: ...22 ...
