MultiSat Control Panel Owner’s Manual
11
Chapter 2 - Installation
Preparing the MCP Mounting Site (Flush Mount only)
NOTE:
Skip this step if you plan to mount the MCP to a horizontal surface.
1.
Using the MCP flush mounting template provided at
the end of this manual (see page 79), mark and cut out a
hole in the mounting surface to accommodate the flush
mount bracket (see Figure 2-3).
Figure 2-3 MCP Mounting Holes Layout
2.
Using the same template, mark the locations for the
four MCP mounting holes.
3.
Using a #29 drill bit, drill a 0.136" (3.45 mm) hole at the
four mounting hole locations. Later, you will mount the
MCP using four #8 screws.
8.87"
(225 mm)
7.62"
(194 mm)
.63"
(16 mm)
3.08"
(78 mm)
1.83"
(46 mm)
.63"
(16 mm)
.136" ( 3.45 mm)
Mounting Hole (x4)
