Operator’s manual for the Pentruder MD1 Modular Drill System with MDU9 Modular Drive Unit - Original instructions
Page 9
2.4.4
RST-CN Rear support
There are two rear supports for the CN-columns. The RST-CN-M is fastened on the male cone at the top of
the column. The RST-CN-U is fastened directly on the column and can be fitted on any side of the column
as there are two openings for the rack and the clamp can be turned upside down as well. The rear supports
are 2.1 meter long when fully pushed in and can be pulled out to a length of 3.2 meters.
RST-CN-U
RST-CN-M
2.4.5
CE1-70 carriage and FE1 Friction clutch
The MD1 drill system with MDU9 Modular Drive Unit is fed manually. To prevent the carriage from sliding
on the column there is a friction clutch fitted on the carriage.
CE1 with FE1 Friction clutch
2.4.6
Pivoting head
•
PD1/PD2 Pivoting head
An universal pivoting head can be used to simplify set-up in many cases. The Pivoting Head can for
example be fitted on a vertical column and a horizontal column fitted to the Pivoting Head conical quick
coupling.
The column quick coupling is of the same type as on Base Plate BE2, with a swiveling face tooth coupling
allowing for adjustment of drill angle in 5° increments.
PD1/PD2
