Copyright © 2012 Tractive Technology, LLC. All rights reserved.
Page 7
Brake Pedal Position Sensor
– Installation
View from under sensor w/plug attached View of harness and wires to tap into
NOTE:
Because the Viper interlock switch is outside the firewall you will need to use (2) of the
provided wire extenders for the set of wires that travel down to the clutch pedal area
FOR THIS
STEP
. This allows the AB harness to be used as-is for the next step which is the clutch interlock
switch.
#1 -
Connects
to
WHITE
on AB
harness
#2 -
Brake
Activated
connects to
BLUE
on AB
harness
CAUTION
: The wires in the schematic
are NOT in the
pictured
order as
physically
in the Viper. Wire#1 (RED)
is your constant (12v+). Wire#2
(LtBlue) is your Brake Activation
signal. Wire #5 (BLACK) is your
ground connection.
TIP
: Due to the limited size of the wire
loom space between wires, install the
wire-tap inner wire 1
st
(Lt Blue). Install
the outer wire for the positive 2
nd
.
ALSO. Because these are adjacent to
each other, attempt to shift/stack one
above the other side-by-side.
Brake switch
#5 -
Connects
to
BLACK
on AB
harness
