Copyright © 2012 Tractive Technology, LLC. All rights reserved.
Page 9
HOW IT WORKS
1.
The “DURATION” dial sets the desirable RPM blip level by opening the throttle. Turn dial
clockwise to increase RPM blip level.
2.
The “DELAY” dial allows for the insertion of a constant time delay from the time a
downshift event is sensed to when the unit blips the throttle. Turn dial clockwise to
increase delay. Range from 0 to 0.5 seconds.
3. The ON/OFF button will toggle between the ON and OFF mode. The unit will default to
the ON state upon power up.
Note: This button is also use to enable the calibration mode. Refer to the Calibrating Unit
section below for more details.
4.
The “STATUS” LED turns on when the unit is ON.
5.
The “BRAKE” LED turns on when the brake pedal is pressed.
6.
The “CLUTCH” LED turns on when the clutch pedal is pressed.
7.
The “BLIP” LED turns on when a throttle blip event occurs.
Note: The
AUTO-BLIP
will automatically turn OFF after 6 hours of inactivity. It will remain
OFF until the ON/OFF button is pressed or power to the unit is removed and re-applied.
The
AUTO-BLiP
monitors your automobile’s accelerator pedal, brake pedal, and clutch
pedal, blipping the throttle only when the clutch pedal is being depressed while
simultaneously braking.
