M 6053 M
rev 16 – 03/2021
Page 25/96
GB
www.tractel.com
MATERIAL CONTROL AND CHECKING
Before each use
Read and respect all conditions given by the magnet instructions for use.
Visually inspect all parts of magnet lifter.
Carefully clean active poles (contact with the load) and if necessary, suppress spotting
out and flashes with a soft file. Never use the magnet lifter with faults on active poles.
Check conditions and functioning of the lever and of the locking device.
A unusual high effort for engaging the lever can signify a load with dimensions
(contact surface, thickness and / or steel type (stainless steel)) which are not
acceptable.
Check correct functioning of the safety locking device after the magnet’s activation :
the safety pin device must quickly and easily return to its initial position. Check correct
functioning of its spring. Never use the magnet if there is a problem with the safety
pin.
Annual checks in accordance with LOLER 1998
Check equipment for any deformation, fissures or other faults. If upper hooking ring
has more than 10 % wear it must be replaced.
Check the active poles condition. If they have faults, they must be cleaned or
corrected by your supplier. Then control lifting capacity of the magnet lifter.
Install the magnet on a load in order to verify functioning and conditions of the
working lever.
Verify condition and functioning of the lever and of the locking device : ensure that the
safety pin device returns quickly and easily to its rest position. Check correct
functioning of its spring.
Check presence and legibility of signalling plate.
Test lifting capacity in accordance with Manufacturers procedure. Lifting capacity with
manufacturer procedure must exceed at least 3 times working load limit of the
magnet lifter.
Log all tests results and findings.
