TRACKMASTER
Ch. 10
Removal and Replacement of Components
317-160-406 Rev 4
TMX428 TMX428CP & TMX58 Service Manual
93
May 2021
23.
Adjust speed sensor to magnet on the flywheel to approximately Reed Sensor 1/16”, Hall
Effect Sensor ¼”.
24.
Reinstall (4) ¼” plastic clamps on the Motor Feedback & Power wires.
25.
Reconnect Motor Feedback 6-pin cable to J1 on the drive.
26.
Reconnect Motor Power 4-pin cable to TB2 on the drive.
27.
to tension drive belt properly.
28.
After installation run treadmill checking for excess vibration and noise from the motor
area.
29.
Replace the hood and screws (5).
(4) ¼”
-20 Nuts
(4) ¼” Flat Washer
Motor Assembly
(4)Screw HHWHTS #8-
32 x 3/8” lg
(4) ¼” Clamp Plastic
TB2 Drive Connector
J1 Drive Connector
(4) MTR Isolation Spacer
(4) MTR Isolation Stem
(4) ¼” Fender Washer
(4) ¼”
-20 x 1-
1/4” Lg