Trackmaster FVX325, Field Service Manual

Page: 39 / 205

TRACKMASTER
5-8
FVX, TMX Series Service Manual August, 2006
FVX__C, TMX__C Manual Controller
Software Download, Control Console Parameters, Speed/Elevation Calibration and Self-test
The following procedures provide instructions to fully utilize the upgrade, diagnostic and
calibration capabilities of the manual controller. Procedures requiring special tools and or
personnel are identified at the beginning of the procedure.
Downloading Software
At Control Console
1. Turn treadmill main power switch to OFF position.
2. Remove (2) Philips screws securing small metal plate covering RS232 port on
backside of control console. (See Figure 1-4)
3. Press the SELECT and the INCLINE (-) keys simultaneously; turn on the main
power, release the SELECT and the INCLINE (-) keys when you hear a continuous
tone. (This may take numerous attempts, as the software has to see both keys
contacted at the same time. This is done to impede the user from inadvertently
accessing the programming mode.)
4. Click on GP32DLG Serial Download icon on laptop or desktop computer. ( ICON )
5. Click on Load S FILE.
6. Select software version provided for download.
(software version XX)
7. Connect serial cable from computer to treadmill control console.
8. Click on Connect .
9. Click on Go .
10. Click on Program All (Continuous tone of control should begin to pulsate while
software is downloading. When pulsating tone changes back to continuous tone,
download is complete).
11. Click on Disconnect and remove serial cable from control box.
12. Turn OFF treadmill main power, replace small metal plate and Phillips screws and
then turn main power switch ON. VER will appear in speed window along with the
new software version number in the time window (See Figure 1-2). This step is
done to verify that the new software has been successfully downloaded.
Tools/Personnel Required: Laptop or Desktop PC with Windows
95 or 98, download program & software, serial data cable, small
Philips screwdriver. Two persons may be required for step 2.
At
Desktop
or Laptop
PC
At
Control
Console