to select correct number. Note that pressing the ENTER key
moves the editor 1 digit to the RIGHT and pressing the
MODE key moves the editor 1 digit to the LEFT.
3. Repeat until frequency at bottom of display matches desired
frequency. Note: that if an active transmitter is within range, it
should be audible. You can adjust the frequency to optimize
the sound by using the
s
or
t
button furthest to the right
before saving the frequency.
4. With the last digit blinking, press ENTER to save the frequency.
A suggested location number will blink. If the desired memo-
ry location is not displayed use the
s
or
t
button to selected
the desired location number.
5. Press ENTER to save the frequency in the displayed memory
location register. This will end the programming mode and
return you to memory location mode
Changing a frequency:
The process of changing a frequency is similar to adding a
frequency. Most users store the new frequency in the old mem-
ory location.
1. Turn ON the receiver.
2. Press MODE button, M changes to CH in mode indication dis-
play line and memory number is replaced by 4 numbers with
the first digit (left) blinking. Note that the current frequency is
displayed at the bottom of LCD.
10
HINT!
It is best to note the memory location you want to store
your frequencies in before initiating the programming mode. After
you key in the desired frequency, the receiver will designate the
lowest available (empty) memory location to store the frequency.
If you have keyed in the desired frequency but forgot the intended
location, press the ON/OFF button for
1
⁄
2
second, this will put you
back into memory selection mode. Then identify the memory
location you want to store the frequency in and start over.
