7
3
4a
4b
4. This step will require two people.
Refer to drawing 4a. Have one person hold out
the Adjustment Knobs (22) on the Right Safety
Spotter (20), while the other person slides the
Safety Spotter down over the right Uprights (7, 8),
as shown. Hold the Adjustment Knob out on the
Right Weight Rest (19), and slide the Weight Rest
onto the Front Upright (7). To avoid breaking the
Square Bushings (21) inside the top and bot-
tom of the Safety Spotter and Weight Rest, be
careful not to catch the Square Bushings on
the edges of the Uprights as they slide on.
Refer to drawing 4b. Secure the Right Safety
Spotter (20) and the Right Weight Rest (19) to the
right Uprights (7, 8) by snapping the three
Adjustment Knobs (22) into adjustment holes in
the Uprights and turning them clockwise until
tight.
Assemble the Left Safety Spotter (not shown) and
Left Weight Rest (not shown) to the left Uprights
(not shown) in the same manner.
Make sure both Safety Spotters and both
Weight Rests are at the same height.
3
1
31
29
29
22
22
7
7
8
8
22
22
20
21
21
21
20
19
19
6
6
7
8
28
3.
Tap a 60mm Square Inner Cap (28) into the top
of each of the Front Uprights (7).
Attach a Front Upright (7) and two Rack Joint
Plates (6) to the Left Base (3) using four M10 x
78mm Bolts (31) and four M10 Nylon Locknuts
(29). Make sure that the Front Upright is
turned so the adjustment holes are facing the
Rear Upright (8), the numbers are on the
inside of the rack, and that the holes near the
bottom of the Front Upright and the holes in
the Joint Plates line up. If they do not line up,
turn the Front Upright upside-down. Do not
tighten the Locknuts yet.
Attach the other Front Upright (7) and two
Rack Joint Plates (6) to the Right Base (1) in
the same manner.
5.
Attach the Chin-up Bar (13) and two Rack Joint
Plates (6) to the Front Uprights (7) using four
M10 x 78mm Bolts (31) and four M10 Nylon
Locknuts (29). Do not tighten the Locknuts yet.
6
29
29
31
31
6
7
13
7
5
Adjustment
Holes
Numbers
