10
24
2
29
15
29
17
17
32
24
23
82
25
23
14. Pull the Long Cable (82) down in the indicated
location, so there is no slack at the ends of the
Cable.
Locate the Short Cable (25), which has a ball on
one end. Insert the eyelet end of the Cable
through the hole in the Foot Plate (5) and into the
indicated hole in the Weight Guide Base (4).
Attach the Cable using an M10 x 75mm Bolt (34),
two M10 Washers (37), two 28mm Spacers (40),
and an M10 Nylon Locknut (29).
Rest the Short Cable (25) in the bracket on the
Center Base (2). Attach the Pulley inside the
bracket using an M10 x 45mm Bolt (32) and an
M10 Nylon Locknut (29).
15. Wrap the Long Cable (82) around a Pulley (24)
as shown. Attach the Pulley and a Cable Trap
(23) to the two Pulley Plates (17) using an M10 x
45mm Bolt (32) and an M10 Nylon Locknut (29).
Wrap the Short Cable (25) around a Pulley (24)
as shown. Attach the Pulley and a Cable Trap
(23) to the Pulley Plates (17) using an M10 x
45mm Bolt (32) and an M10 Nylon Locknut (29).
Make sure that the M10 x 45mm Bolts (32) are
inserted through the highest and lowest holes
in the Pulley Plates (17), and that the Cables
(25, 82) are between the Cable Traps (23) and
the Pulleys (24).
32
5
34
37
37
40
4
40
25
82
14
16
45
47
47
16. Wet the ends of the Lat Bar (45) with soapy
water. Slide the Handgrips (47) onto the ends of
the Lat Bar.
Make sure that all parts of the weight rack are
properly tightened. In addition, pull each cable
a few times to make sure the cables move
smoothly over the pulleys. If the cables do not
move smoothly, locate and correct the prob-
lem. When weights are used, the cables may
be damaged if they are incorrectly routed.
