21
WWW.
TRACKWRENCH.COM
4.3.3.
Current
Settings
Figure 4.3.3.: Current Settings
1.
Sleep:
The time in minutes before the Torque Device will enter
sleep mode if left idle. If the operator applies torque or
uses the torque device control buttons the sleep counter
is reset. The Torque Device will not enter sleep while connected
via USB to PC.
2.
Units:
Current units of measurement (Nm is the default setting).
3.
Just Move (Deg)°:
The default Just Move angle setting,
which is the angle at which a snapshot of the torque is taken
during the Just Move mode application.
4.3.4.
Preset
Configuration
Figure 4.3.4.: Preset Configuration Screen
The Preset Configuration Screen shows the presets that are stored on
the Torque Device. Presets can be configured either in the PCFE or on
the Torque Device.
For instructions on how to add a preset using the PCFE, please see the
section “Set a Preset using the PCFE”.
