TD-W8960NB
300Mbps Wireless N ADSL2+ Modem Router User Guide
The WAN Interface List displays the Lay2 Interfaces you have configured on the section
4.4.1
Layer2 Interface
and its default MAC Address. If you have not configured corresponding WAN
Service for the interface on the section
4.4.2 WAN Service
, the blank for MAC Address will display
“Need a corresponding WAN Service”.
The last one of WAN Interface List displays your PC’s current address.
Figure 4-23
Type the new value for the WAN Interface who’s MAC Address you want to change, and click
Save/Apply
.
You can select corresponding WAN Interface from the drop-down list and click
Clone
button to
clone your current PC MAC, and then click
Save/Apply
.
Click
Restore Default
button to restore the WAN Interface’s default MAC Address.
)
Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.
4.4.5 NAT
NAT (Network Address Translation) allows you to share one WAN (Wide Area Network) IP
address for multiple computers on your LAN (Local Area Network).
)
Note:
When you select
PPPoA
or
PPPoE
for the WAN Setup, or when you select
Enable NAT
for the
type of
IPoA
and
IPoE
connection (
4.4.2 WAN Service
), you will see the
NAT
menu in the
Web-based Utility (shown in Figure 4-24).
Choose “
Advanced Setup
”
Æ
“
NAT
”, there are three submenus under the main menu
: Virtual
Servers
,
Port Triggering
and
DMZ Host
. Click any of them, and you will be able to configure the
corresponding function.
32
