TD-W8950ND
150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-9
4. Enter the following parameters and then click
Next
.
Figure 4-10
¾
PPP Username/Password
: Enter the User Name and Password provided by your ISP.
These fields are case-sensitive.
¾
PPPoE Service Name
: Enter the Service Name if it was provided by your ISP. If you leave it
blank, the default name will be the same as the
Service Description
on the previous screen.
¾
Authentication Method
: Select the
Authentication Method
from the drop-down list, the
default method is
AUTO
, and you can leave it as a default setting.
)
Note:
If you are not sure about the
PPP IP extension
and
PPP Debug Mode
etc. below, please don’t
select these options.
¾
MTU(bytes)
: Maximum Transmission Unit Size. Check this box then you can change the MTU
size. The default
MTU
value is 1480 Bytes. It is not recommended that you change the default
value unless required by your ISP.
¾
Enable Fullcone NAT
: It is a type of NAT, if not enabled, the default NAT will act.
23
