TL-WA501G
54M Wireless Access Point User Guide
Chapter 4: TCP/IP Configuration
After connecting the TL-WA501G AP into your network, you should configure it. The
default IP address of the TL-WA501G 54Mbps Wireless Access Point is 192.168.1.1,
and the default Subnet Mask is 255.255.255.0. These values can be seen from the LAN.
They can be changed as you desire, as an example we use the default values for
description in this guide.
Connect the local PCs to the LAN ports on the AP. There are then two means to
configure the IP address for your PCs.
¾
Configure the IP address manually
1) Set up the TCP/IP Protocol for your PC(s). If you need instructions as to how to
do this, please refer to
Appendix B: "Configuring the PCs."
2) Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is
from 2 to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1
(The AP's default IP address)
¾
Obtain an IP address automatically
1) Set up the TCP/IP Protocol in "
Obtain an IP address automatically
" mode on
your PC(s). If you need instructions as to how to do this, please refer to
Appendix B: "Configuring the PCs."
2) Power off the AP and PC(s). Then turn on the AP, and restart the PC(s). The
built-in DHCP server will assign IP addresses for the PC(s).
Now, you can run the Ping command in the
command prompt
to verify the network
connection between your PC(s) and the AP. The following example is in Windows 2000
OS.
Open a command prompt, and type
ping 192.168.1.1
, then press
Enter
.
Figure 4-1: Successful result of Ping command
If the result displayed is similar to that shown in figure 4-1, the connection between your
PC and the AP has been established.
-
8
-