Toyotomi CCT 100HINVi, Service Manual

Page: 48 / 76

Troubleshooting
Electrical Control System 111
Control chip is in main PCB
NO. 1 2 3 4 5
Color Orange Grey White Pink Black
Signal Hu Hv Hw Vcc GND
Color Red Blue Yellow
Signal
W V U
1) Release the UVW connector. Measure the resistance of U-V, U-W, V-W. If the resistance is not equal to each other, the fan
motor must have problems and need to be replaced. Otherwise, go to step 2.
2) Power on and when the unit is in standby, measure the voltage of pin4-5 in feedback signal connector. If the value is not 5V,
change the PCB. Otherwise, go to step 3.
3) Rotate the fan by hand, measure the voltage of pin1-5, pin 2-5 and pin 3-5 in feedback signal connector. If any voltage is
not positive voltage fluctuation, the fan motor must have problems and need to be replaced.