Toyota 1996 Celica, Owner'S Manual

Page: 44 / 203

37
(B)TOP STRAP ANCHORS AND LOCA-
TIONS (Coupe and liftback only)
Coupe—On the filler panel behind the
rear seat
a. Using the illustration as a guide, run
your fingers across the trim of the filler
panel itself to locate the position of the
holes underneath.
b. Make a hole in the covering directly
above the hole in the filler panel.
c. Insert a 15 mm (0.6 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5–24.7 N
⋅
m (1.68–2.52 kgf-
⋅
m, 12.2–18.2 ft
⋅
lbf).
To comply with Canada Motor Vehicle
Safety Standards, vehicles sold in Cana-
da are provided with a bracket set in the
glovebox, designed for use with any of the
2 anchor locations shown in the illustra-
tion.
Liftback (right seat)—On the luggage
compartment floor
a. Using the illustration as a guide, un-
cover the anchor by rolling back the car-
pet on the luggage compartment floor.
The anchor hole is sealed.
b. Remove the seal of the anchor.
c. Insert a 15 mm (0.6 in.) spacer and
tighten down the anchor bracket for your
child restraint system with a bolt. Torque
the bolt to 16.5—24.7 N
⋅
m (1.68—2.52
kgf
⋅
m, 12.2—18.2 ftl
⋅
bf).
To comply with Canada Motor Vehicle
Safety Standards, vehicles sold in Cana-
da are provided with a bracket set in the
glovebox.
http://www.carownersmanual.net
carownersmanual.net
carownersmanual.net