2. Make four (4) small holes on the wall as per the
mounting dimension diagram. (Fig. 13)
3. Fix the four (4) mounting rubbers to the wall by
using the wood screws and the washers.
In this case, do not tighten the mounting
rubbers excessively. (Fig. 14)
4. Install the mounting plate over the mounting
rubbers using the holes. Slide the mounting
plate down. (Fig. A,B)
5. Tighten the four (4) screws securely. Be sure not
to touch the motor's cooling fan or the control box
with the screwdriver.
14
Small hole
Entrance side
Exit side
Mounting rubber
Washer
Wood screw
Mounting rubber
Top corners of
Mounting plate
Hooking hole
Mounting rubber
Tighten to the extent that the
mounting bushings rotate slightly.
Bottom corners of
Mounting plate
6.06"
about 1.38"
3.03"
1.06" 0.94"
8.54"
Hooking hole
Fig. 13
Fig. A
Fig. B
Fig. 14
