1. Remove the 2 inner screws from the upper heat shield. (Fig. #43)
2. Slip the top porcelain panel into the lip at the front of the firebox and tip the
panel up to align with the screw holes. Secure with the previously removed
screws. (Fig. #44)
3. Insert the back panel into the firebox by tilting the panel and rest the panel
on the seat tabs at the back of the firebox. (Fig. #45)
NOTE: Seat tabs can be lowered if the rear panel is tight.
NOTE: Centering tabs on the panel should be located at the outside of
the seat tabs.
4. While supporting the back panel insert the left side panel into the firebox
Position the top of the panel against the side of the unit, inserting the top
panel tab into the slot at the top of the side panel and slide the bottom into
position. (Fig. #46)
NOTE: Notch at bottom of side panel faces to front of unit.
5. Repeat step 4 for the other side panel.
NOTE: Install burner now.
6. Place the front panel on the front lip of the firebox, wide flange facing the
front. (Fig. #47)(Proceed to step #7 if you are installing a TCWS.54NG03.C2
Black Diamond burner with this unit.)
7. Place the other front panel piece at the rear of the firebox with the
wide flange facing to the rear against the back panel.
Fig. #43
Fig. #44
Fig. #46
Fig. #45
Fig. #47
SEAT TABS
28
TCWS54_D 281114-44
Firebox Panels Installation
Summary of Contents for TCWS54 SERIES D
Page 39: ...Fig 65 39 TCWS54_D 281114 44 Wiring Diagram ...
Page 42: ...42 TCWS54_D 281114 44 ...
Page 43: ...43 TCWS54_D 281114 44 ...
