6
PREPARATION
Use a model airplane covering iron with a protective covering
sock to remove any wrinkles present in the covering. The
best temperature setting, with a covering sock on the iron,
is approximately 300° F. If this doesn’t seem to be enough
heat to shrink the wrinkles, increase iron temperature in small
increments until the wrinkles disappear.
WING ASSEMBLY
❏
1. You will need to make two wing joiners. Each joiner
should be made from one piece of plywood and one piece
of aluminum. Look at the pieces and notice that they can
only match up one way (be sure you will be joining the layers
together correctly). Coat one side of one of the pieces with
epoxy (6-minute or 30-minute) and sandwich them together.
CONTENTS
1. Center Wing w/ Spoiler
2. Outer Wing Panels
3. Fuselage
4. Canopy Hatch
5. Horz. Stab w/Elevator
6. Vert. Fin w/Rudder
7. Wing Joiners
8. ESC
9. Spinner Cone
10. Folding Prop Blades
11. Spoiler Servo Tray
12. Wing Dowels, Bolt
Plate, Alignment Pins
13. Vert. Fin Gussets
14. Hook & Loop Material
15. Hinge Tape
16. Tail Pushrods
17. Hardware Bag
1
4
7
2
5
8
3
6
9
10
11
12
13
14
15
16
17
