9
❏
10. A roll of clear tape is included to hinge the spoiler to
the wing center section (if you ever need to replace the hinge
tape, regular, clear offi ce tape will work fi ne). Center the
spoiler in the opening on the wing and confi rm the fi t. The
spoiler should lay fl at in the opening and the leading edge
must be tight to the sheeting. If you see any warping, remove
the spoiler from the wing and use your covering iron or heat
gun to heat the warped end while bending the spoiler gently
in the opposite direction of the warp. Let the covering cool
before releasing the spoiler. Check your results and repeat
if necessary.
❏
11. Place the spoiler servo into the servo tray. Install the
top plate over the servo using the two 2.5 x 10mm self-
tapping screws.
7/8" [ 22 mm]
❏
12. The simplest way to get the screw on the servo arm
into the spoiler bracket slot is to use pliers to fl ex the servo
arm as shown. You can also loosen the screw and nut from
the servo arm. Now would be a good time to temporarily hook
up the spoiler servo to your receiver and test it using your
transmitter. Use your end point adjustments in the transmitter
to ensure the servo isn’t binding when the spoiler is moved
from down to up. If your transmitter does not have end point
adjustment, you will need to adjust the servo arm position
on the output spline and/or the hole position of the bracket
screw on the servo arm.
