Tower Hobbies T19005, Safety And Instruction Manual

Page: 15 / 20

Safety and Instruction Manual
15 Helpline: +44 (0) 844 984 0055
4 TROUBLE SHOOTING & FAQ’S
Questions Answers
Can I operate the
grinder empty?
No. Running the grinder dry could damage the head.
Are any of the parts
and accessories
dishwasher safe?
No. We recommend cleaning all the accessories in warm soapy water so as not
to damage the finish.
Where can I buy
sausage casings? You can purchase natural casings from your local butcher, or look online on
sausage making websites for a variety of natural and synthetic casings.
How can I clean
excess meat out of the
grinder?
Feed chunks of stale bread or toast through the grinder. This helps to clear the
last pieces of ground meat out.
What do I do if my
grinder gets jammed?
If your grinder is jammed, or if the motor slows or stops you need to switch it to
the reverse position. To do this, switch the grinder off.
Move ON/OFF/REV switch to the REV position, and turn the grinder back on.
This will reverse the flow of the product. The worm will begin rotating in the
opposite direction, thus empting the horn of the grinder.
Can I add food to
my grinder before
switching it on?
No. The grinder must always be switched on before adding any food.
Meat does not flow
through the grinder.
Make sure the grinder head is properly assembled.
What are the sizes of
the cutting blades?
Fine: 3mm
Medium: 5mm
Coarse: 7 mm
Meat is not feeding
through correctly
Check that the cutting blade is assembled correctly. Ensure the meat is boneless
and sinewless.
Check that the food pipe is full of meat. Air pockets inside can result in an
inconsistent finished product.
Check the extruder ring and screw assembly are correctly in place.
If you continue to have problems, run the meat through the grinder suing the
coarse cutting blade first, and then use the medium or fine blade afterwards.
White meat is more difficult to grind that red meat (red meats mince easier).
Ensure any white meat is diced into small portions before grinding.
What is the best way
to clean the cutting
blades?
Wash them in warm soapy water. Never store them wet. If they are not being
used immediately after washing, wipe them with mineral oil.
Always inspect the blades regularly to ensure that all the holes are clear of
bones, bits of gristle or over foreign materials. Clean the holes with wire as often
as possible.
How long can I operate
the grinder for? Do not operate the grinder for more than 30 minutes at any one time. After 30
minutes of continuous use, allow a few minutes to rest before using again.