8
Register online at www.towerhousewares.co.uk for your
FREE
extended guarantee.
3 USING YOUR APPLIANCE
Before first use:
Ensure that the voltage indicated on the rating
label corresponds to the mains voltage in your
home.
Wash all parts (except the main body of the
appliance) in warm, soapy water and dry.
Before plugging in the appliance, make sure the
on/off switch is in the off position.
Assembly:
1. Take the horn and insert it into the head
inlet, slanted slightly downwards. Take the
fastening screw and screw it into the side of
the motor housing. Hold onto the horn and
turn the screw clockwise to fasten it into
place. (see Fig 1)
2. Fit the worm into the horn, with the shorter
end facing out. The longer end will set into
the motor housing loosely. (see Fig 2)
3. Place the cutting blade onto the end of
the worm, with the blades facing inwards
towards the inside of the horn. (see Fig 2)
NOTE:
If the cutting blade is not fit properly, the
meat will not grind.
4. Place the desired cutting plate on top of the
cutting blade. It will position onto the slots
either side on the horn. This will then hold
the worm in place. (see Fig 3)
5. Screw the fixing ring tightly into place on
top of the cutting blade. Ensure not to over
tighten. (see Fig 4)
6. Place the hopper plate on to the horn and
fit it into position. (see Fig 5)
7. Place the unit on a steady, dry surface.
NOTE:
Ensure the air passages at the bottom
and side of the motor housing are not blocked at
any time.
Fig 1.
Fig 5.
Fig 2.
Fig 3.
Fig 4.
