5
❏
3. Flip the assembly over. Using care not to lay it back down
over any uncured CA on the plastic sheet, wipe any excess
CA off the bottom.
❏
4. Glue the
left
and
right
side doublers
to the bottom
fuselage half — the left side is the one with the “Y” groove and
the right side has just a single slot — little glue is required, but
you
do
want to apply it evenly and get it all the way to the edges.
❏
5. Glue the bottom fuselage half to the wing/horizontal
fuselage section. As you proceed, use a small builder’s square
to make certain the fuselage side is perpendicular.
❏
6. Use medium-grit sandpaper to round both ends of all
the 1mm carbon fi ber braces — you don’t need to sand them
to a sharp point — just take off the rough edges.
Summary of Contents for Laser 200 Flatty
Page 16: ......
