tousek ST 63, Connection And Installation Manual

Page: 30 / 40

- 30 -
tousek / EN_ST-63_02 / 25. 03. 2020
important: preparation works
• All electrical installations (control panels, safety devices ...) have to be made in full conformity with the applying rules
and laws.
Attention: if no stop switch is connected then the terminals KL1 30/31 have to be bridged.
• The mechanical limits have to be placed so that contact edges are not triggered, as this would lead to an
error message.
• Unlock emergency release of operator and set gate to half-opened position. Then lock the operator again.
• Switch on the operator (correct connection necessary).
• Important: Putting into operation in Impulse mode (standard setting) and not in dead man mode.
• During initial operation the choices of language and gate type (swing- or folding gate) are made first, afterwards
in the „ Basic settings ” the adjustment of the most important operator settings. After the successfull system test the
detection of limit positions of gate is performed automatically.
LANGUAGE and GATE TYPE SELECTION
• Can be selected during initial operation (hence after reset to factory settings).
• Language selection can be also chosen by pressing the ESC button ( ) for 5s , from any position in menu.
BASIC SETTINGS
• For setting the most important adjustments for initial operation of motor.
• Can be selected during initial operation (hence when restoring the factory setting).
• All safety devices are activated when leaving factory
(

page 13, 14).
•
The next programming adjustments are made in THE MAIN SETTINGS MENU
(

page 12–14).
factory settings
PHC = photocell
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
PHC inside
3
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
during closing
reverse
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
PHC inside
not active
change? YES
confirm
3
4
inner photocell
REVERSING
Select a setting (+/-):

not active

during closing
reverse

stop, open after
release

during open stop,
then open
inner photocell
e.g.
return
to previous location
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
gate type
swing gate
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
language
Deutsch
1
scroll confirm
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
basic settings
confirm
2a
3
2c
putting into operation
(same step after
factory reset)
5s ESC
(language selection)
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
gate type
swing gate
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
gate type
folding gate
swing gate folding gate
confirm change? YES
2a
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
operator
X3TP
2b
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
operator
X3TP
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
operator
X4TP
X3TP X4TP
confirm change? YES
2b
4. Putting into operation
ST 63 control unit for folding and swing gates