-25-
6. OPERATING PROCEDURES
WARNING
Please be careful to operate the machine while saw blade
is running and always DO NOT to use the machine unless
all of the guards and other safety devices are in good
working order.
6.1 MACHINE START AND STOP
The switch’s positon of the machine is as the picture
shown.
6.1.1
A-Deflection display panel
B-Main blade start button
C-Main blade stop button
D-Scoring blade start button
E-Scoring blade stop button
F-Main blade revolving speed display lamp
G-Main blade rise and fall rotary knob
H-Emergency stop button
I-Main blade deflection rotary knob
J-Emergency stop button
K-Main power control switch
Fig.6.1.1
B
C
D
E
G
I
H
A
F
K
J
6.1.2
short press
：
ESC long press
：
clear away
deviation value, long press again will return to value
before clear away
short press: increase button long press: show
original angle value
short press: transposition
short press: confirm long press: enter into menu
Machine makes interior adjustment when leave production
line. If move machine or remount , please pay attention to
angle.
If angle of digital readout is not fit with actual value, please
operate in below steps:
- Make the blade in 90° position, long press “ZERO”
button
，
clear the angle to zero;
- Make the blade in 45° position
，
long press “END”
button, set angle to 45°
；
- If not correct, please adjust deflection position of reaction
block A(on movement) , until value correct. As png
6.1.2.2
。
Fig.6.1.2.1
-14-
4
A
图
.6.1.2.2
Fig.6.1.2.2
Summary of Contents for Diamond 400
Page 54: ......
