38
39
Freeze Damage Prevention
What to Do?
If you cannot operate with the remote control
The batteries may have worn out.
Replace the batteries.
■
Replacing the batteries
1
Unplug the power plug.
The POWER LED goes o
ff
.
2
Remove the remote control from the hanger.
(Page14)
3
Open the battery cover and replace the
AA batteries.
(Page14)
Lit
4
Mount the remote control in the hanger.
5
Insert the power plug.
The POWER LED lights up.
How to freeze damage prevention
(continued)
3
Drain the pipe.
(1) Extend the wand.
Operate with the buttons on the back
side of the remote control.
1. Press [MENU].
2. Use
to select "CLEANING".
Press [ENTER].
3. Use
to select "WAND
CLEANING MODE ON/OFF".
Press [ENTER] to extend the wand.
Hold the wand in the extended
position until no more water comes
from around the wand.
Press [ENTER] again to retract the wand.
(Release the pressure from the
water supply pipe.)
(2) Unplug the power plug.
(3) Remove the cover and water
fi
lter
drain valve.
Cover
Water
fi
lter drain valve
(4) Drain the water from the water
supply hose.
Water supply hose
Horizontally
(5) After draining the water, install the
water
fi
lter drain valve and cover.
Insert the water
fi
lter drain valve and use a
fl
at-head screwdriver to tighten it securely.
(6) Insert the power plug.
4
Check that the POWER LED
on the main display is lit up.
(Page 15)
5
Set the water and toilet seat
temperature to "High".
(Page 22)
(To maintain the temperature.)
When
fi
nished, close the toilet seat and toilet lid.
■
To use the Washlet again
The water needs to be resupplied. (See below)
When the ambient temperature is likely to drop to 0°C (32°F) or lower, take measures to
prevent freezing.
Attention!
●
When the ambient temperature is likely to drop to 0°C (32°F) or lower, do not use the energy saver feature.
(May damage the product.)
●
Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 0°C (32°F).
How to freeze damage prevention
■
How to drain the water
1
Close the shuto
ff
valve.
Do not remove the water
fi
lter drain
valve while the shuto
ff
valve is open.
(Otherwise, water may leak out)
CAUTION
2
Drain the water from
the toilet tank.
Turn the
fl
ush handle of the toilet
tank to the full
fl
ush side.
Turn the lever until water
fl
ow stops.
Resupplying the Water
1
Open the shuto
ff
valve.
• Check that water is not leaking from a pipe or the main unit.
2
If the power is not turned ON
Insert the power plug.
3
Discharge water from the wand.
(1) Pressing down the right side of the toilet seat,
(2) Press [REAR] on the remote control to discharge water from the wand for about two minutes.
(It takes about one minute maximum before water comes out. Catch the water in a paper cup or other receptacle.)
■
If the remaining water has frozen and no water comes out
•Heat the inside of the bathroom, and warm the water supply hose and shuto
ff
valve using a cloth soaked in warm water.
Soft cloth soaked in water
(to prevent scratching)
Paper cup
Reference
