16
1. Shift the mode to the installation checking mode.
When your hand is held under the sensor for about 8 sec during
the first 10 minutes after the power is turned on, the mode shifts
to the “Installation Mode”.
During sensing, the liquid soap pump is driven and the liquid
soap continues to come out. (30 sec at maximum)
The liquid soap stops when your hand leaves the sensor.
Use this function for filling an empty flow path with liquid soap.
3. Check the tank and the connection of the
liquid soap hose for any liquid soap leaks.
TESTING
Checking after the completion of installation.
After installation is complete, confirm that the dispenser is working properly using the following method.
After the installation has been compleated, test the product using the following procedure.
Caution
If more than 10 minutes pass since the power was turned on, pull out the power plug and insert it
again.
When disconnecting and reconnecting the power plug , pull out the power plug and leave it
unplug for longer than 10 sec.
Caution
If the product is not used for a long period of time after installation, liquid soap remaining in the
hose dries and dispenses poorly. Therefore, conduct the
trial run with water
.
After the trial run, leave water accumulated in the tank as is and replace it with liquid soap at the
beginning of actual use.
Sensor
Checking for leaks
2. Dispense and stop the liquid soap.
The liquid soap comes out when you bring
your hand under the sensor.
The liquid soap stops when your hand
leaves the sensor.
EN
GL
IS
H
17
HOW TO USE
Place Hands Under Dispenser Spout.
Dispenser Spout
When the sensor senses someone’s hands, it
dispenses a mousse-like liquid soap.
The dispensing time is approximately 0.5 second.
Dispensing stops when the hand is taken away
from the dispenser.
If one’s hands remain in front of the dispenser,
the mousse-like liquid soap will again be
dispensed after approximately a 3 seconds delay.
This process can be repeated up to three times.
In order to prevent misuse, the liquid soap
dispenser will stop dispensing after 3 times, but
repeated soap dispensing is possible by moving
the hands away and placing them in front of the
dispenser again.
* This function does not work for the first 10 min.
after the power is turned on.
(See page 16 "Installation Mode")
Please do not obstruct the dispenser spout
opening.
The soap might fly off in an unexpected direction.
Please do not put foam on the tip of the
dispenser. If the sensor is blocked, it could
malfunction.
When the tip is blocked , please wipe away the
debris using a damp cloth.
EN
GL
IS
H
