20
CARE AND CLEANING
For Light Cleaning
For Heavy-Duty Cleaning
Sensor surface
Dispenser spout
Detergents containing acid, chlorine bleach or
alkali.
Solvents like paint thinner or benzene.
Detergents with coarse granules, polishing
powder or cleanser. Nylon scrubbers, pot
scrubbers, brushes, etc.
Please use a cloth that has been soaked in water
and wipe away any debris adhering to the
dispenser or sensor.
After wiping away debris with a cloth containing a
suitable amount of a neutral, dishwashing
detergent, wipe clean with a damp cloth.
When cleaning around the sensor, please be
careful not to scratch the surface of the sensor.
Please avoid using cleansers that might scratch
the surface of dispenser.
These include:
EN
GL
IS
H
21
PERIODIC MAINTENANCE - Nozzle
●
How to mount the nozzle
* Be sure to mount the nozzle so that the spill
hole comes to the lower side. Otherwise,
liquid soap may leak.
1. Pull out the power plug.
Note
After the nozzle has been mounted, turn on
the liquid soap, and make sure that water does
not leak from the outside of the nozzle.
Note
After washing them with water, wipe off
moisture with a dry soft cloth.
If you use hot water for cleaning, dirt is
washed off more easily.
2. Turn the nozzle by hand to unlock.
3. Grab the projection on the nozzle with a
tool such as long-nose pliers and pull out
the nozzle and the filter.
4. Clean (Wash with water) the nozzle and the
filter.
5. After washing the nozzle and the filter,
mount them back again.
When mounting the nozzle, turn it by hand
so that it
locks with the spill hole to the
lower side
.
* The nozzle is made so as not to insert
reversely.
Nozzle
O-ring
Tool
Filter
Spill ports
Unlock
View from below
Caution
If you wash the nozzle in a wash bowl, block
the drain outlet. This part is small and may be
lost.
EN
GL
IS
H
