Do not use power tool
Anchoring plate
Countersunk
tapping screw
Front
Back
Countersunk
tapping screw
(5/32”×25/64”
(4×10))
Front panel
Wood screw
(13/64”×1-1/4”(5.1×32))
Wood screw
(13/64”×1-1/4”(5.1×32))
Mounting bracket
Washer (Not supplied)
Washer (Not supplied)
Wall anchor
Wall anchor
Anchoring plate
Tilt the Controller as shown and mount to the
Mounting bracket.
Push firmly to the end of the Mounting bracket.
INSTALLATION PROCEDURE
Securing on the floor
We recommend installing in a covered location such as under a counter behind a front panel.
(Scale: inch(mm))
< For concrete floor / sub-floor >
Please install wall anchors
< For wood floor / sub-floor >
Please be sure to secure to plywood at least 19/32” (15mm)
thick.
Please prepare and install the included wood screws
(13/64”×1-1/4”(5.1mm×32mm)) and metal washers on-site when
securing.
3. Secure the Anchoring plate to the Controller with
one countersunk tapping screw.
4. Put the Mounting bracket in position and secure it
with two wood screws.
5. Attach the Controller to the Mounting bracket, and fix the Anchoring plate with one
wood screw.
NOTE
When installed in an exposed location, there is a risk that the Controller may tip over if
excessive external force is applied.
NOTE
• Please tighten by hand without using a power tool.
• Please do not confuse the front and back of the Anchoring plate.
Do not damage the power cord.
ENGLISH
14
